The provided 2-1/4” screws will be used to secure hinge plate 4 through the upper jamb into the door header. Predrill holes for remaining screws for each of the hinge plates. Adjust hinges as needed by using slotted holes in hinge plates. A slight gap between the bookcase and face frame is necessary to allow clearance for the bookcase to swing. Verify the fit of the trim against the installed Invisidoor. Use of Locktite can prevent set screw from twisting loose over time. Align the upper hinges and screw the set screw into the hinge plate on the header. Set the hinge on the bottom of the bookcase onto the pin of the hinge plate on the threshold. Thread the included setscrew/capscrew into the threaded.įor an outswing door, you will work from the backside of the Invisidoor to put it into place on the lower hinge pin and install the capscrew through the top. Mount hinge plate #2 to the top of the bookcase. Then drill a 5/8” hole from the inside of the bookcase through the top to avoid tear out inside the bookcase.) (Predrill a small hole from the top of the bookcase. Use the diagrams for the location of this hole. Prior to installing the upper hinge on an outswing door to the bookcase, an access hole for the set screw must be drilled through the top of the bookcase. Use the mounting diagram to install hinge plate #1 to the bottom of the bookcase. Use blocks of a different thickness to create appropriate height and margin for your application. Install the mounting blocks (usually two 11/16” blocks on the bottom and one 1/2” on the top) to the hinged side of the bookcase unit. Shim the jamb as needed at location of pivot hinge for a solid mounting area with longer hinge plate screws mounted into header for final installation. Install a hinge plate #4 to the upper jamb. Place the two steel washers and bronze bearing onto the hinge pin as shown. Use the diagrams to install hinge plate #3 to threshold/floor. Walls more than a standard 2” x 4” thick may require modification for an inswing door application. Trim will later be mounted over the drywall and bookcase face frame, spanning across the jamb. In most cases, the bookcase face frame will be flush with the drywall. Use the diagrams to identify locations for the pivot hinge to be installed on the left or right side of the unit as either an outswing (which pulls out toward the bookcase side) or an inswing (which rotates away from the bookcase side). Left and right edge of the face frame rounded over with 3/8” radius bit.The thickness of the blocks may need to be adjusted based on the clearance and spacing needed for the door.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |